Suitable Replacement Poulan 1950 Bar & Chain Combo
The bar is made of high quality super
tough chrome-moly steel. The bar rails are heat treated to provide
superior wear and bar body strength. If the sprocket nose is broken or
locked up, the bar needs to be replaced. The sole purpose of the bar
is to guide the chain in the wood for a clean and straight cut. To get maximum power and performance out of your chain saw and
optimum power when cutting wood, make sure your saw has a new suitable replacement Poulan 1950 Bar & Chain Combo.
Performance Parts Supply Poulan 1950 bar & chain combo parts meet or exceed OEM specifications and they cost less than OEM bar & chain combos while maintaining excellent quality and durability. Bar & Chain Combo parts should either be replaced or cleaned per
manufacturers specifications that are located in your owners manual. You can quickly buy our suitable replacement Poulan 1950 Chainsaw Air Filter for sale in our online store and get it shipped fast.
Poulan 1950 Bar & Chain Combo - General Information
The chain cutter‹??s job is to cut the
wood efficiently in a single pass as the cutter rides in the bar. The
cutters are made of superior quality high strength chrome-moly steel.
The cutters can be a either a full chisel square corner cutter or a
semi-chisel cutter. For top performance and fast cutting chain speed,
use chisel chain. The chisel chain is a top performing chain that
severs the wood fibers fast and effectively. If the wood is dirty or
the conditions are not favorable, use the semi chisel chain for
reliability, durability and longer use between chain sharpening.
The Poulan 1950 bar may need periodic maintenance.
If the rails are sharp or rolled over, they will need to be dressed
up by removing the rolled edge with a file, a bar rail dresser, or a
hand grinder to remove the rolled edge and true the bar rail to be
square and true again.
The Poulan 1950 chain needs to be sharp to cut wood
fast. Forcing the chain to cut can cause premature wear on the bar
rails and stretch the chain. When the chain is sharp, you will get
wood chips and the saw will feed itself into the wood without using
force to make it cut. A dull chain will produce dust and maybe some
chips, the dust will clog up the air filter and might pass right
through the air filter and damage the engine. Another consequence
could be overheating the engine resulting in premature engine
Remember, the best saw to cut wood with should have a good sharp chain and good bar to guide the chain. That is why we recommend buying our Poulan 1950 Bar & Chain Combo so you have both of the critical ingredients to fast cutting!
Important Notice - We are not affiliated with any chainsaw manufacturers and we do not attempt to make any affiliations with them. Any manufacturer logos, model names and numbers are the sole property of their respective owners and are used here for the sole purpose of reference. We do not sell OEM chainsaw parts for any brand. We do however, offer high quality suitable replacement parts guaranteed to meet or beat OEM part specifications like our suitable replacement Chainsaw Poulan 1950 Bar & Chain Combo we offer for sale for you to buy and put into their brand of chainsaws.